How To Fix Xbox Buttons
Introduction
This guide will teach you how to remove the buttons.
-
-
Remove the battery pack cover.
-
Remove batteries.
-
-
-
We recommend using a nylon spudger for this step. A metal spudger is shown.
-
Grip the controller firmly to remove the side handles, wedging a spudger into the seam between the front and handle plates.
-
Pry the side plate away from the front plate by moving the spudger back and forth. You will need to do this all the way around the side plate's seam.
-
-
-
There is a hidden screw located in the middle of the controller behind the label.
-
Use a screwdriver and punch a hole directly in the center of the label.
-
You may also lift the label if you do not want to puncture it.
-
Remove the five 10mm screws located on the back of the controller using the T8 Security Torx Screwdriver.
-
-
-
Remove the backplate.
-
-
-
Remove the faceplate.
-
-
-
You may let the rumble motors hang freely out of their sockets.
-
De-solder the soldered joints while holding the red and black wires down on the top motherboard.
-
De-solder the black and gray wires that are attached to the top motherboard.
-
Remove the rumble motors and set them aside.
-
Be careful while using the soldering iron not to damage other components or hurt yourself.
-
For information on how to solder, click here.
-
-
-
Unscrew the two 7mm T6 screws located near the rumble motor sockets.
-
-
-
Firmly grip sides of motherboard near the middle.
-
Lift upwards while slightly wiggling the motherboard forward and backward.
-
Lifting the motherboard will require some force.
-
-
-
Remove the six T6 Torx screws located on the bottom motherboard.
-
-
-
Remove the bumpers by prying them off of the pegs that secure them, using a spudger. They are located on the front and back of the controller.
-
A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard as shown risks damaging your device.
-
-
-
Lift the piece surrounding the Home button off of its pegs.
-
Pry it off of the other side, using a spudger on the pins.
-
A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard as shown risks damaging your device.
-
Removing this piece may require a lot of force.
-
-
-
Remove the bottom motherboard.
-
-
-
Remove the rubber backing to the buttons.
-
-
-
With the buttons facing down, push them up out of their housings, and remove.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.
Preview
How To Fix Xbox Buttons
Source: https://www.ifixit.com/Guide/Xbox+One+Wireless+Controller+Buttons+Replacement/36845
Posted by: batchelorcomitaxby1995.blogspot.com
0 Response to "How To Fix Xbox Buttons"
Post a Comment